Hi
I am doing analysis for a mechanical room to study the forced stack effect. The wind is forced into the space through by fans placed in front of louvered openings on both sides of the room at floor level. There is an opening at the clerestory level and a fan facilitates the exhaust. For boundary ...
Search found 4 matches
- Mon May 18, 2015 7:55 pm
- Forum: MicroFlo
- Topic: Placing boundary condition fan on ejecting side
- Replies: 0
- Views: 13061
- Thu May 07, 2015 4:18 pm
- Forum: ModelIT
- Topic: Dxf image not showing up correctly
- Replies: 6
- Views: 12111
Re: Dxf image not showing up correctly
Hi
Where in IES do I check to ensure that the Dxf is imported in correct scale
Scale Factor
Plane
Maximum arc-chord distance
Please guide me through the steps.
Where in IES do I check to ensure that the Dxf is imported in correct scale
Scale Factor
Plane
Maximum arc-chord distance
Please guide me through the steps.
- Tue Apr 28, 2015 6:10 pm
- Forum: ModelIT
- Topic: Modeling exterior Plaza
- Replies: 1
- Views: 5622
Modeling exterior Plaza
I have a large plaza within the model which is not a conditioned space. But the lighting loads ( exterior lighting) within that space needs to be plugged into the energy simulation.
Does this mean that the space needs to be modeled as a room or any other way to plug it in?
If I make it a room how ...
Does this mean that the space needs to be modeled as a room or any other way to plug it in?
If I make it a room how ...
- Mon Apr 20, 2015 11:04 pm
- Forum: ModelIT
- Topic: Not able to change location in APlocate
- Replies: 1
- Views: 5741
Not able to change location in APlocate
I am trying to change my project location from the default. I am able to change the location in APlocate tabs, however that change is not reflected in the bottom corner of the page as it still shows Denver Airport as location. Can you please advice how to proceed.