IES-VE User Forum

Hello All,

I've been advised to input a 5m3/hm2 air infiltration rate. Considering that the pressure in IES is set @50 P, what's the best way to convert this to ach? CIBSE TM23 recommends to multiply times the surface-volume ratio, but result seems to high.

Could anybody give me an advise on this ...

Hello everybody,

I'm trying to produce an SBEM calculation on IES. The systems consists of a heat pump and underfloor heating.

Is is it possible to put the SCOP of the heat pump or only the seasonal efficiency? The manufacture shows 157% of seasonal efficiency and I'm a bit concerned because it ...

Thanks!

I'v exported the model as VE Geometry (GEM) and it worked fine. It was an easy job...
I couldn't make it through VE Green Building xml (gbXML). What's the main difference actually?

Hello everyone,

I'm trying to redo a building model, but I want to keep the geometry. Basically, I need to delete all thermal templates and constructions. I've tried two options below:

1. Copying the geometry from ModelIT to a new project. Is there any way to do this?
2. Removing the thermal ...