IES-VE User Forum

I've gone through your options, but nothing is behaving strangely in the model as far as I can tell. Would it be possible to send you my model if it's a case of 5 minutes?

The part I'm most confused about is that it shouldn't be physically possible for the steady state to be lower than the dynamic ...

Hi Complex Potential,

Thanks for the quick reply.

Macroflo and SunCast are not active on the dynamic run. However, Aux. and natural ventilation are in both dynamic and CIBSE load.

Any ideas?! I'm at a total loss with this one, and a deadline this coming Friday.

Thanks again for your help,

Sean

Hi,

After completing checking through my simulation results I have found that the CIBSE heat load figure is considerably lower than my dynamic annual simulation peak value.

At first, I considered the outdoor temperature value was too low for the CIBSE calc. so I changed it from -3.6 deg. cels ...

Hi All,

There is probably something small I am missing but whenever I calculate domestic hot water load I receive values for each room but the when I look at the whole building output there is a 0kW output throughout the year. This is impossible as if all rooms have an identified load this should ...