IES-VE User Forum

I know its been answered quite a while ago. While i did included holes with in my model and then try to run the Apache sim in VE compliance, strange problem does appeared. For instant when i am in VE compliance (Apache sim- as default) I did click on Set building & system data > simulation settings ...

Dear All,

I have a simple query regarding SFP (W/l/s) value which determines the Auxiliary Energy. I am working on hotel development where Fan coil units (FCU) are specified for the hotel guest bedrooms. Apparently i did receive a FCU schedule from the manufacturer and total numbers of FC-Units ...

Hi ya,

At the moment i am working on Hotel development where the hotel consists of 6 basement floors. In each basement floor there is an exhaust air duct shaft which is passing from basement 06 to basement 01 and to ground floor. Apparently all the shaft openings via the basements are complete ...

Further to my earlier query...

Does the cibse loads purely based on room template values like heating/cooling temparatures, gains & infiltration. OR ELSE the CIBSE loads would also depend on the corresponding NCM system too?

Dear All,

Basically i have run cibse loads for a hotel project from APCHE module and end up lets say 500KW(After suncast)
After the load results I have run the Dynamic simulation (part-L) complaince and again run the loads from the same point like Vista results. My query is does the CIBSE load ...

Could some one let me know how to show granite cladding and portland stone cladding on external wall of the building in modelIT.

Cheers
Kiran.Tati

Hi ya,

I am about to start modelling a building which has 6 floors under the basement and they are not exposed to sun or atmosphere, there fore no solar gains I suppose. Apparently in Suncast i have taken some example buildings for practice purpose and the floors below basement does showed solar ...

Hi ya

Could some one let me know how to create wooden Louvers on external wall?

I am wondering how the wall with Louvers can reflect on U value for Ex. wall.

Cheers

Hi ya,

I am wondering does any one know how to draw/create Roof by manually rather choose the option in Model IT. I Hope some one would share their ideas

Cheers
K.T

hi ya,

recently i came to know about Part L1- JPA|TL software interface. While i was trying to export IES(.mit) file into JPA (SAP) software it display error like DER file version should be 3.0. Can some one tell me what does it means.

Cheers
Kiran.Tati