Heating Detail Breakdown

[mechah]

Hi,

Been using IES for a while now, but theres one issue in particular that is bugging me:

When I do a CIBSE load calculation, I can get the heat loss per room from the report. BUT, what I need for comparison/analysis purposes is a breakdown of where the heat loss is from, Eg. 100w through external wall, 500w through glazing etc. This would then enable me to do a thorough check on the heat losses. All I can see is 500w external conduction, 1000w infiltration etc, with no breakdown of where these figures come from.

Does anyone know how to do this? Your help is appreciated!

[Complex Potential]

Hi Mechah

I think that the option to itemize the conduction gains by surface type is only available under ApacheSim (dynamic) models and not ApacheLoads.

CP