Dear All,
In my new project navigator ASHRAE 90.1 App. G -PRM,
In final report at table 1.8.2 (Performance Rating Table- PRM Compliance) the "fans Interior" in "Proposed Building Results" is" 0",
As I check all are the same as I usually done, but the problem still appear, Do you have any recommended for me?! It never happened for any one?! any suggestion to check some item? or ...
Regards,
Sahar
Fans Interior
Re: Fans Interior
Hi,
I had a scan through our support knowledge base but don't see any report of this in the past. My best guess would be that the appropriate fuel code hasn't been assigned in your model. "Fans interior" is one of the fuel codes so the Report won't be populated based on the components in your model and HVAC but rather from whatever Fuel Codes are assigned to the appropriate parts of the model (I expect you know this already from the User Guides and Training but worth noting here on the forum) so it could be that this code isn't correctly assigned or the component it is assigned to in your model isn't actually being include dint he simulation?
worth having a check through the Proposed model to just make sure, it will probably jump out to you when you look at the fans and another fuel code is assigned there somehow. If you used the pre-defined prototype systems then this would be applied by default unless it was later overridden.
Phil
I had a scan through our support knowledge base but don't see any report of this in the past. My best guess would be that the appropriate fuel code hasn't been assigned in your model. "Fans interior" is one of the fuel codes so the Report won't be populated based on the components in your model and HVAC but rather from whatever Fuel Codes are assigned to the appropriate parts of the model (I expect you know this already from the User Guides and Training but worth noting here on the forum) so it could be that this code isn't correctly assigned or the component it is assigned to in your model isn't actually being include dint he simulation?
worth having a check through the Proposed model to just make sure, it will probably jump out to you when you look at the fans and another fuel code is assigned there somehow. If you used the pre-defined prototype systems then this would be applied by default unless it was later overridden.
Phil
IES Worldwide Technical Support