Just been going through slicing some spaces without partitions with the partition tool or with the edit space tool.
I have encountered quite a few crashes when using the edit space and slicing around 5 slices...
Any ideas as to why this keeps crashing. I used to be able to edit an entire floor and then separate the spaces. Now I have had to save between every cut as it tends to crash first cut or at max 5th cut...
Once I managed to get my slices and separate zones in place I had further issues.
Its odd because the ground floor worked perfectly fine (excluding the crashes), sensors for daylight harvesting were placed throughout the model as expected.
However the remaining 4 or so floors did not have their sensors placed.
I have recreated this with a plain old box. I can get a single sensor in the box however when i divide the space with either tool, Radiance does not recognise the spaces and does not insert sensors whether the space is divided as separate zones or with partitions etc...
Maybe I should have modelled this in VE 2013 as last time I used that it was fine.
Before adding the sensors:
After adding the sensors. For some reason sensors only appear on one side and on the ground floor...
Even ceiling spaces are not fully sensored even though they have had no modifications to the spaces at all.
Are the sensors actually there but not being displayed correctly? I am running proof simulations to see if this is the case.
Any help would be great.