Can someone please tell me how to draw partitions from gypsum within an open space in a building?
Thank you a lot
Gypsy partitions
-
vajindarladdad
- Site Admin
- Posts: 217
- Joined: Wed Sep 09, 2009 8:56 am
Re: Gypsy partitions
Hi,
Draw a simple wall & assign construction properties of gypsum in construction set to the wall.
Partitioning a room:
1) Select a room you wish to partition.
2) Click 'Draw partition to divide selected space' button from the toolbar.
3) Draw a partition line you wish to.
I hope this has been of some help.
One more thing , If you have not attened any training session for IES<VE> then I would strongly recommend you to go for it.
IES Training Program
http://www.iesve.com/training
Draw a simple wall & assign construction properties of gypsum in construction set to the wall.
Partitioning a room:
1) Select a room you wish to partition.
2) Click 'Draw partition to divide selected space' button from the toolbar.
3) Draw a partition line you wish to.
I hope this has been of some help.
One more thing , If you have not attened any training session for IES<VE> then I would strongly recommend you to go for it.
IES Training Program
http://www.iesve.com/training
Thanks & Regards ,
_________________
Vajindar Laddad
_________________
Vajindar Laddad
Re: Gypsy partitions
Hi,
Thank you very much for your answer, actually my problem was more about how to draw the partition and not how to made it be from gypsum but finally I found it out.
Can i ask you another thing. Can you please tell me how to delete a partition because it doesn't behave as a normal wall right?
Thank you again for your help.
Thank you very much for your answer, actually my problem was more about how to draw the partition and not how to made it be from gypsum but finally I found it out.
Can i ask you another thing. Can you please tell me how to delete a partition because it doesn't behave as a normal wall right?
Thank you again for your help.
Re: Gypsy partitions
tom
don't think of "adding" partitions in IES because that's not what it's doing - it models volumes so you are in effect drawing different rooms for each partitioned space. If you want to remove partitions then either draw a 100% hole between the spaces or merge the things.
zap
don't think of "adding" partitions in IES because that's not what it's doing - it models volumes so you are in effect drawing different rooms for each partitioned space. If you want to remove partitions then either draw a 100% hole between the spaces or merge the things.
zap