Non existing node

[PCully]

Hi,

I don't know why the node number would be greater than the nodes in your network (perhaps something to do with a multiplex?). Check that you are running the sim linked to the same HVAC network you are working with in ApacheHVAC (just to make sure).

From looking at previous reports the Flow over-specified can be linked to different problems in the network usually to do with Controllers being linked to too many variables, too many controllers or an unrealistic control. I don't really know how to find out where or what's gone wrong when the node number doesn't mean anything on your network though I'm afraid.

If you have a maintenance or Support Credits then I'm sure the Tech Support team would be able to fix it or point out the error otherwise it's just a case of going through the network to see what's gone wrong. sorry I can't help you out more

Phil

[PCully]

I don't have much experience troubleshooting HVAC networks, maybe try copy the whole network (inside the same asp file) and delete the original, that way it should be forced to refresh the node numbers. Take a backup first in case it goes bad!

Phil