[Solved] - Error: Insufficient Control Description

[AlexMcC]

Hey there,

I'm having a bit of an issue when trying to run my model. I have a fairly large model with several "multiplex" systems within it. I have just added two new rooms into one of these Multiplex modules. When I go to apache to run the model, I recieve the error: Flow at node 103/ cannot be set - insufficient control description.

Note that before I added these two rooms into the model, it was running fine without the error listed above.

I realise that I most likely have to include some sort of additional controller module into the model, but am unsure on which one. How might I add a 'control description' to this particualr node? Has anyone had a similar issue before and managed to resolve it? Any help in fixing this error would be much appreciated.

Cheers,
Alex

[AlexMcC]

Nevermind, the node that was registered to be 'at fault' was actually downstream of the node with the actual issue. I guess one just needs to track back through all of their flow paths to check all control descriptions in the model.