Sizing of radiators
Posted: Mon Jun 28, 2010 11:20 am
Hi
Is there any possible way for IES to autosize the radiators in a room?
From the ApacheView manual, it says the CIBSE Loads simulations will record the maximum heating demand for a rooom but when i run the simulation, the heating unit stays at 0kW. Why is that?
Can someone please help on this?
Cheers
Is there any possible way for IES to autosize the radiators in a room?
From the ApacheView manual, it says the CIBSE Loads simulations will record the maximum heating demand for a rooom but when i run the simulation, the heating unit stays at 0kW. Why is that?
Can someone please help on this?
Cheers