Page 1 of 1
Electrical systems through gas consumption results
Posted: Tue Nov 09, 2010 8:51 am
by V Cardona
Hi everyone,
I specified all of my systems as electrical and when I run the simulation I get gas consumption results as well as electrical. Did I miss something, should I ignore them? Hope somebody can help me, thank you.
Re: Electrical systems through gas consumption results
Posted: Tue Nov 09, 2010 11:09 am
by PCully
Hi,
I don't think you should ignore this if it was unexpected! Review all your model inputs to see where gas is being used. Use the tools in Vista to help identify what is using gas, for example review each system individually to see if it is one of the systems etc.
Phil
Re: Electrical systems through gas consumption results
Posted: Tue Nov 16, 2010 5:13 am
by V Cardona
Thank you Phil. I found it was the DWH, is the a way to configure it as electrical in the wizard?
Re: Electrical systems through gas consumption results
Posted: Tue Nov 16, 2010 9:05 am
by PCully
Find out what apache system you are using to provide the DHW and change the Heating Generator Fuel to Electricity.
Phil