Page 1 of 1
Plan view in MacroFlo
Posted: Fri Jun 17, 2011 7:17 pm
by ahcag
After runing a simulation, I tried to save an image in MacroFlo but it is always a perspectif view.
Is it possible to save a plan, like paralel projection view?
Thanks.
Re: Plan view in MacroFlo
Posted: Sat Jun 18, 2011 7:03 am
by vajindarladdad
Hi,
You can change the 'View' using 'View rotation drop-down' there isn't a button where you can save the image.
(You can use 'PrintScreen' keyboard button to take image.)
However , you can save the image when you are viewing model in 'Model Viewer' (in any view you wish).
I hope this has been of some help.