Re: construct-dxf
Posted: Mon Jun 22, 2009 8:46 am
Hi,
Your DXF won't be following the basic rules defined within the ConstructDXF drawing requirements guide - have a read of that in the manuals section to see where you've went wrong. More than likely you don't have room names in a single layer within each space. You might find better results tracing to grid rather than using ConstructDXF but that's up to you.
Your DXF won't be following the basic rules defined within the ConstructDXF drawing requirements guide - have a read of that in the manuals section to see where you've went wrong. More than likely you don't have room names in a single layer within each space. You might find better results tracing to grid rather than using ConstructDXF but that's up to you.