Apache Hvac Error - NOTE: Oversizing factors
Posted: Tue Nov 06, 2012 1:00 pm
Hello,
I was runing Ashrae Loads and i wanted to see the loads for each room (file extension is .htn and .cln) but i got this message that i can see these results only in "prototype system sizing", so i went to my navigator and chose this option and i could see my results only that in the section where i should see the table with room loads, fresh air, people, etc. i was getting only this message "NOTE: Oversizing factors used in sizing HVAC system equipment are not applied to peak loads in this report."
How can i correct this problem in order to get that nice table as i was getting it with .htg and .clg files ?
I was runing Ashrae Loads and i wanted to see the loads for each room (file extension is .htn and .cln) but i got this message that i can see these results only in "prototype system sizing", so i went to my navigator and chose this option and i could see my results only that in the section where i should see the table with room loads, fresh air, people, etc. i was getting only this message "NOTE: Oversizing factors used in sizing HVAC system equipment are not applied to peak loads in this report."
How can i correct this problem in order to get that nice table as i was getting it with .htg and .clg files ?