IES-VE User Forum

Hey there,

I'm having a bit of an issue when trying to run my model. I have a fairly large model with several "multiplex" systems within it. I have just added two new rooms into one of these Multiplex modules. When I go to apache to run the model, I recieve the error: Flow at node 103/ cannot be set - insufficient control description.

Note that before I added these two rooms into the model, it was running fine without the error listed above.

I realise that I most likely have to include some sort of additional controller module into the model, but am unsure on which one. How might I add a 'control description' to this particualr node? Has anyone had a similar issue before and managed to resolve it? Any help in fixing this error would be much appreciated.

Cheers,
Alex

Nevermind, the node that was registered to be 'at fault' was actually downstream of the node with the actual issue. I guess one just needs to track back through all of their flow paths to check all control descriptions in the model.