Hi all
is there any chance/possibility to change Load calc spreadsheet from IP unit to SI unit?
Regards
zhang xiangjing
IP unit to SI unit for LEED PRM
Re: IP unit to SI unit for LEED PRM
Hi,
Unfortunately not, I think the spreadsheet will always work in IP units but we do plan to phase out the dependency on it this year and replace with a real interface in VE which you will have options with units again. I think if we were going to have the spreadsheets any longer then we would be able to put more work into making it easier to use with areas like this but the time is better spent replacing the spreadsheets altogether so it is worth living with for now to get a better tool to use very soon
Phil
Unfortunately not, I think the spreadsheet will always work in IP units but we do plan to phase out the dependency on it this year and replace with a real interface in VE which you will have options with units again. I think if we were going to have the spreadsheets any longer then we would be able to put more work into making it easier to use with areas like this but the time is better spent replacing the spreadsheets altogether so it is worth living with for now to get a better tool to use very soon
Phil
IES Worldwide Technical Support