Hi, a request for help:
Is there a way within the software to view the amount of heat flux through a given wall, or floor etc. And plot this as a graph or data file?
Any help greatly appreciated.
Thanks
Rich
Heat flux through wall
-
Complex Potential
- VE Expert
- Posts: 467
- Joined: Wed Jan 09, 2013 11:57 am
- Location: Bristol, UK
Re: Heat flux through wall
Richard
When you go to run an apache simulation click on the "Output Options" button and then click "Conduction gains breakdown" under both the all rooms and detailed lists and ensure that all of the rooms at the bottom are highlighted (holding shift and click is your friend here).
Once the simulation is run select a room or group of rooms and you should see additional conduction gain options within the vista results that can be broken down into walls, roof, ground etc. Additionally you can then drill down to a specific surface and interrogate those individually.
CP
When you go to run an apache simulation click on the "Output Options" button and then click "Conduction gains breakdown" under both the all rooms and detailed lists and ensure that all of the rooms at the bottom are highlighted (holding shift and click is your friend here).
Once the simulation is run select a room or group of rooms and you should see additional conduction gain options within the vista results that can be broken down into walls, roof, ground etc. Additionally you can then drill down to a specific surface and interrogate those individually.
CP