Page 1 of 1
VE MFC Application has stopped working VE 2013
Posted: Sat Jul 27, 2013 8:01 am
by Richardo1505
I have just updated to VE 2013.0.01. Radiance seems very buggy. When I place sensors and run Apache it gets to June and then crashes out. the message is VE MFC Application has stopped working. is this a known issue, can anyone offer some advice please.
Thanks, Richard
Re: VE MFC Application has stopped working VE 2013
Posted: Tue Jul 30, 2013 10:18 am
by PCully
Hi Richard,
There is no known issue and the sensors worked ok for a test model I just created.
Check your geometry first, then have a look at the placement of your sensors and make sure they are placed in reasonable parts of each room and pointing in the right direction.
If it consistently fails for a certain model then please send to
feedback@iesve.com so we can pass on to our developers and if possible improve the software.
Phil