Process Loads
Posted: Mon Aug 05, 2013 1:02 pm
Hello-
I have a building with an addition and the original building is being retrofit as well. However, the LEED project only includes the New Construction addition area, not the retrofit areas. The building HVAC system consist of zone water-to-air heat pumps with a common condenser loop (heat transfer loop), closed circuit coolers and boiler. The retrofit zones are connected to the common condenser loop, however I am not planning on modeling them specifically but would like to approximate their affect on the common condenser loop. In DOE2 this could be completed by adding a process load and schedule directly to the loop, is there a way to do this in IES?
Thanks in advance for your help.
I have a building with an addition and the original building is being retrofit as well. However, the LEED project only includes the New Construction addition area, not the retrofit areas. The building HVAC system consist of zone water-to-air heat pumps with a common condenser loop (heat transfer loop), closed circuit coolers and boiler. The retrofit zones are connected to the common condenser loop, however I am not planning on modeling them specifically but would like to approximate their affect on the common condenser loop. In DOE2 this could be completed by adding a process load and schedule directly to the loop, is there a way to do this in IES?
Thanks in advance for your help.