Construct DXF

[ric123]

I have done up a plan of a building and I have brought into ModelIT But in following the principles of ConstructDXF DXF Drawing Requirements User Guide I have put a rectangle around the entire dxf drawing. Though it is extracted and all looks fine I will like to remove the rectangle as it is not part of the drawing
Any help?

[PCully]

Do you just want to not see the rectangle now? If the geometry is built you can just detach the DXF again?

Phil

[ric123]

Do you just want to not see the rectangle now? If the geometry is built you can just detach the DXF again?

Phil

I am at loss building without the rectangle. When I use construct DXF, all the lines are extruded including the rectangle and it looks like a box even though the real plan is not a rectangle If there is a way to build the walls of each room then I think that would be fine
Thanks

[PCully]

I still don't understand, are you ending up with an extra box around the model? If so you could just delete it after you have done the Extrude DXF

Phil

[ric123]

I still don't understand, are you ending up with an extra box around the model? If so you could just delete it after you have done the Extrude DXF

Phil

Thanks I did not know delete would work
Thanks