IES-VE User Forum

I have done up a plan of a building and I have brought into ModelIT But in following the principles of ConstructDXF DXF Drawing Requirements User Guide I have put a rectangle around the entire dxf drawing. Though it is extracted and all looks fine I will like to remove the rectangle as it is not part of the drawing
Any help?

Do you just want to not see the rectangle now? If the geometry is built you can just detach the DXF again?

Phil

PCully wrote:Do you just want to not see the rectangle now? If the geometry is built you can just detach the DXF again?

Phil

I am at loss building without the rectangle. When I use construct DXF, all the lines are extruded including the rectangle and it looks like a box even though the real plan is not a rectangle If there is a way to build the walls of each room then I think that would be fine
Thanks

I still don't understand, are you ending up with an extra box around the model? If so you could just delete it after you have done the Extrude DXF

Phil

PCully wrote:I still don't understand, are you ending up with an extra box around the model? If so you could just delete it after you have done the Extrude DXF

Phil

Thanks I did not know delete would work
Thanks