Page 1 of 1
Room Volume Intersecting
Posted: Mon Nov 25, 2013 10:05 am
by ric123
I have just built a model and I suspect the rooms intersect. Any ideas please on how to check and solve this problem without having to rebuild my model
Thanks
ric123
Re: Room Volume Intersecting
Posted: Tue Nov 26, 2013 12:14 pm
by bootsam
In ModelIT. Go to top bar - SETTINGS/MODEL tick intersections and then press CHECK
Tip - do this often when building models to check it
Re: Room Volume Intersecting
Posted: Sat Nov 30, 2013 10:59 pm
by ric123
bootsam wrote:In ModelIT. Go to top bar - SETTINGS/MODEL tick intersections and then press CHECK
Tip - do this often when building models to check it
Thanks
That seems to be ok but my fear is after finding the intersected volumes would I have to rebuild the model? Is there a way to assign intersected models rightly to where they belong? Is this done automatically ?
Thx
Re: Room Volume Intersecting
Posted: Mon Dec 02, 2013 4:30 pm
by JohnLloyd
If you have intersecting rooms, find them, and use the 'Draw Partitions' button to remove the overlap.