Invalid Profile References
Posted: Fri Jan 31, 2014 6:05 pm
If you see the following message after opening a project then it usually means that some of the NCM profiles referenced in the thermal templates are not currently in the project.
There have been a few updates to the NCM database which has resulted in NCM Profiles being updated, so a profile that had the ID NCMW0001 in VE 2012 might now be NCMW0002 in VE 2013. When you go into VE Compliance it will sort itself out as it picks up the correct profiles for each NCM activity. Problems can occur though if you were referencing NCM profiles in the real building templates for ApacheSim; but that goes against our official guidance so you shouldn’t be doing that anyway
There have been a few updates to the NCM database which has resulted in NCM Profiles being updated, so a profile that had the ID NCMW0001 in VE 2012 might now be NCMW0002 in VE 2013. When you go into VE Compliance it will sort itself out as it picks up the correct profiles for each NCM activity. Problems can occur though if you were referencing NCM profiles in the real building templates for ApacheSim; but that goes against our official guidance so you shouldn’t be doing that anyway