Immediate crash after entering VE Compliance
Posted: Fri Jan 29, 2016 12:18 pm
I've finished creating a model and am now beginning to test its compliance with the Regs;L2_ENGLAND license installed.
I started to install the lighting for a single room whilst on the VE compliance tab - set up building templates (Internal gains) - edit internal gains. I chose to adjust the internal gain I had already defined and set across all thermal templates in a previous test run.
Once I unticked 'Assigned to a template', IES crashed. Since then IES slows down and crashes after a little wait, closing the program.
I was about to reinstall IES but then I noticed that I was able to access the VE compliance tab with a different model open. Suggesting that my model could be corrupted in some way.
Does anyone have any suggestions on how to fix this?
Cheers,
Harry
I started to install the lighting for a single room whilst on the VE compliance tab - set up building templates (Internal gains) - edit internal gains. I chose to adjust the internal gain I had already defined and set across all thermal templates in a previous test run.
Once I unticked 'Assigned to a template', IES crashed. Since then IES slows down and crashes after a little wait, closing the program.
I was about to reinstall IES but then I noticed that I was able to access the VE compliance tab with a different model open. Suggesting that my model could be corrupted in some way.
Does anyone have any suggestions on how to fix this?
Cheers,
Harry