Tabular Room Data (Geometry)
Posted: Thu Jun 05, 2014 8:39 am
Hi, I have quite a number of flats in a couple of tower blocks modelled. I have used Macroflo to specify some as openable and some as not. Part F of the BR's state HxW of openings etc. I can see the actual area of opening from the tabular data and also as a percentage of floor area. But this is only the opening area of the actual opening and not the HxW as per Part F. Is there a tab for this? Theres so many.
I guess i can fudge it by setting side hinged windows at 90° open and sliding balcony doors at 100% in macroflo. Is this correct?
I guess i can fudge it by setting side hinged windows at 90° open and sliding balcony doors at 100% in macroflo. Is this correct?