Heating Set Point Error/Help ???!!
Posted: Wed Mar 11, 2015 9:36 am
I am currently running an apache simulation on a building to get me heat losses and heat gains.
I have set up all the room conditions to be 19-21 degrees for heating set point.
i then run the apache and the CIBSE loads calculations and when i look at the report my buildings heat demand is next to 0. i looked through the individual room resukts in the report and it shows some of the heating set points as 4.5 degrees and after playing around with it even more i went worse and to -1.5 degrees.
has anyone else suffered of this problem and have a fix ?
much appreciated.
I have set up all the room conditions to be 19-21 degrees for heating set point.
i then run the apache and the CIBSE loads calculations and when i look at the report my buildings heat demand is next to 0. i looked through the individual room resukts in the report and it shows some of the heating set points as 4.5 degrees and after playing around with it even more i went worse and to -1.5 degrees.
has anyone else suffered of this problem and have a fix ?
much appreciated.