Re: ConstructDXF and windows
Posted: Fri Sep 25, 2009 2:57 pm
Well done,
Just been trying a few different scenarios to get windows to come through ConstructDXF with single line models and found the same solution.
Modelling the windows as rectangles with one edge against the wall surface then make sure the correct layer for windows is chosen on the Settings and the constructed model has windows in all the right places.
A good tip for other users
Phil
Just been trying a few different scenarios to get windows to come through ConstructDXF with single line models and found the same solution.
Modelling the windows as rectangles with one edge against the wall surface then make sure the correct layer for windows is chosen on the Settings and the constructed model has windows in all the right places.
A good tip for other users
Phil