IES-VE User Forum

Hello all,

I am trying to model a residential building which is designed with a boiler and radiator. However I have created hot water loop including boiler and two individual radiators for seperate rooms. But I have problem when simulating model as' mismatch variable (temp )'. Also program forced me to put sensors then I have placed sensors to room input and output line. But still same problem exists.

Do you have any idea about this?

Reagrds.

You can find the screenshoths of the system below.

Hi,

I think you would benefit from some Training from IES in this area. We offer e-training options which will cover all the basics of configuring your networks for both airside and waterside/plant.

http://www.iesve.com/training/subjects/ ... apachehvac

There are also some pre-defined systems you can import and reference meantime to see who these should be configured. There are very simple cases if the Prototype systems are a little overwhelming at first. I'd also suggest you have a read through the ApacheHVAC User Guide since it gives rules for controller placement (re sensors and controlled nodes)

http://www.iesve.com/support/userguides

Phil