Peak flow rates from Macroflo in Microflo
Posted: Fri Jun 12, 2015 2:46 pm
Hello
I would like to check the values that have been imported from Macroflo in my model for my boundary conditions on the door/louvered openings. At the moment, I run my microflo simulation and converges but it does not show any flow, which is why I would like to check that the boundary conditions are correct.
Thanks
Bing
I would like to check the values that have been imported from Macroflo in my model for my boundary conditions on the door/louvered openings. At the moment, I run my microflo simulation and converges but it does not show any flow, which is why I would like to check that the boundary conditions are correct.
Thanks
Bing