Page 1 of 1
v2015.1 - "Error in profile evaluation" ?
Posted: Fri Sep 18, 2015 9:33 am
by claireinkling
When trying to run a CIBSE loads calc I am getting the error "Error in profile evaluation" ?
I've never seen that before. Obviously I'll review the profiles but I'm not sure how they can be 'wrong'.
Anyone have any ideas?
Re: v2015.1 - "Error in profile evaluation" ?
Posted: Fri Oct 09, 2015 1:21 pm
by PCully
I know this has been resolved already but for benefit of the forum
We detected an issue with a few models where blind profiles were set to None and it caused this error running the calculations, if you change them to be off then you should find the calculations will complete
Phil
Re: v2015.1 - "Error in profile evaluation" ?
Posted: Thu Dec 17, 2015 6:21 pm
by alexpjackson
I am also trying to run a 'CIBSE' calculation and an error message saying "Error in profile evaluation'.
I do not seem to have any rooms set with blind profiles so was wondering if there was any suggestion to help clear my issue?