Entering a heat exchanger into ISBEM
Posted: Fri Aug 19, 2016 1:51 pm
I am using the standard iSEBM software and have a new build which is to have a Biomass boiler situated externally to the actual building which is providing heat to a heat exchanger within the buildings plant room, which is then to provide underfloor heating.
The same heat exchanger is to also provide heat to an Air Handling Unit.
At present I have entered the AHU under a single duct VAV with LTHW Boiler as the heat source and Biomass as the fuel type.
The Underfloor heating is currently entered as Central heating using water; floor heating with LTHW Boiler as the heat source and Biomass as the Fuel type.
Is this acceptable or should I request the Heat Exchanger efficiency and input the systems differently?
Many thanks in advance for any assistance
The same heat exchanger is to also provide heat to an Air Handling Unit.
At present I have entered the AHU under a single duct VAV with LTHW Boiler as the heat source and Biomass as the fuel type.
The Underfloor heating is currently entered as Central heating using water; floor heating with LTHW Boiler as the heat source and Biomass as the Fuel type.
Is this acceptable or should I request the Heat Exchanger efficiency and input the systems differently?
Many thanks in advance for any assistance