Water side editing
Posted: Thu Sep 08, 2016 2:05 am
Hi all,
I am now modeling a chiller system in a high rise building and in my case there will be pressure breaks for chilled water supply for mid zone and high zone office area. however, I found that there is no way to edit the water side design, with only the default of chillers, water pumps and coils in the system diagram. Is it possible to add the heat exchanger in between and an additional pump for the mid-zone chilled water supply? if not, is there any ways to reflect the actual system configuration?
I am now modeling a chiller system in a high rise building and in my case there will be pressure breaks for chilled water supply for mid zone and high zone office area. however, I found that there is no way to edit the water side design, with only the default of chillers, water pumps and coils in the system diagram. Is it possible to add the heat exchanger in between and an additional pump for the mid-zone chilled water supply? if not, is there any ways to reflect the actual system configuration?