'VE MFC Application has stopped working' - please help
Posted: Mon Feb 20, 2017 4:54 pm
My simulation crashed/stopped when reaching 99.900% completeness. A pop-up window showed, saying 'VE MFC Application has stopped working'. This has happened several times, for several floors (I have split my model by floors as it is extensive), but always consistently when reaching 99.900%.
I was using the 'mid' analysis settings. The same model has got through no problem when using the 'min' setting, so I assume that the model its self (i.e. geometry) is not causing the problem.
Has anyone experienced the same issue?
I was using the 'mid' analysis settings. The same model has got through no problem when using the 'min' setting, so I assume that the model its self (i.e. geometry) is not causing the problem.
Has anyone experienced the same issue?