PRM System Load Calculations - Error mismatch
Posted: Tue Apr 25, 2017 3:33 pm
Hello,
I am currently trying to run a PRM simulation and when I reach the system load calculations for the proposed system, it brings up the following error:
"Mismatch between controlled variable (temp ) and module type (fan), node 311 "
I have located the node and its a duct between a fan and a heating coil, but I cant seem to be able to solve this one.
Does anyone know how to address this error?
Thank you,
Terry
I am currently trying to run a PRM simulation and when I reach the system load calculations for the proposed system, it brings up the following error:
"Mismatch between controlled variable (temp ) and module type (fan), node 311 "
I have located the node and its a duct between a fan and a heating coil, but I cant seem to be able to solve this one.
Does anyone know how to address this error?
Thank you,
Terry