Possible BUG: meters reset after closing VE
Posted: Mon Jun 12, 2017 2:00 pm
Dear all,
I have noticed that when I assign meters to my model/s , internal gains meters reset back to 'meter1', which I believe is the default one. This is also the case after saving the project, or closing then openning VE again. I will, in this case, need to re-assign them manually, which is quite an unnecessary task.
Somthing I noticed that might have been the cause is that when I create a System in 'Apache Systems' and try to change the meter of that system to another one, it rolls it out to all other Apache Systems! the only place I can assign a different meters to internal gains is via Tabular Room-Thermal....Thanks.
Regards,
Yahya
I have noticed that when I assign meters to my model/s , internal gains meters reset back to 'meter1', which I believe is the default one. This is also the case after saving the project, or closing then openning VE again. I will, in this case, need to re-assign them manually, which is quite an unnecessary task.
Somthing I noticed that might have been the cause is that when I create a System in 'Apache Systems' and try to change the meter of that system to another one, it rolls it out to all other Apache Systems! the only place I can assign a different meters to internal gains is via Tabular Room-Thermal....Thanks.
Regards,
Yahya