Page 1 of 1
Divide with Partition to Divide without Partition
Posted: Thu Nov 05, 2015 12:25 am
by joshpmoorman
I have been drawing a building based on DXFs and drawing the footprint then using internal partitions to divide up the internal spaces. After finishing, I realized that some spaces that were divided with partitions and should have been divided without partitions. Is there a way to make this change without merging and re-partitioning the spaces or drawing holes over 100% of the walls?
Thanks
Re: Divide with Partition to Divide without Partition
Posted: Thu Nov 05, 2015 2:32 pm
by Complex Potential
You could use the connect spaces tool to combine all zones without partitions and then split them back out again. This will have the disadvantage of losing room naming if you have progressed that far though.
Re: Divide with Partition to Divide without Partition
Posted: Mon Dec 14, 2015 2:49 pm
by DonS
There is a key-in - "adjhole" which creates holes between adjacent surfaces for all the selected spaces.